I have a 2 bay SATA dock connected to a laptop via USB that detects the drives without any difficulty. I would appreciate any input from you… I have a My Book Live Duo 6TB in “spanning” modeġ - I cannot seem to read either of the drive’s contents with DiskInternals in order to access any of my information as complete or usable files (I am very limited in Linux knowledge) and would like to make a backup of whatever information I can get off of the drives, especially about a 1 and 1/2 years of photos of my three daughters. MyBookLiveDuo:~# Filename Type Size Used Priority MyBookLiveDuo:~# MyBookLiveDuo:~# swapon -s Md0 : active raid1 sda2 2 sda1 3 sdb2 sdb1 Number Start End Size File system Name Flagsģ 15.7MB 528MB 513MB linux-swap(v1) primary raid Sector size (logical/physical): 512B/512B Welcome to GNU Parted! Type ‘help’ to view a list of commands. However I managed to connect through ssh, ran the commans for swap etc as described in guide and also took some stats. If I place only the new drive in case A, then I get the loading bar again saying disk is initializing. If I place only the old working disk in case A, then I can access the dashboard. I followed everything as Guide 2/3 described but MBL has still red color and I can’t access the Dashboard cause I always get the loading bar saying disk is initializing. I bought a replacement which is 2TB WD Blue Series and tried to replace it. The problem now is that one of the drives (Drive B 2TB WD Green Series) failed as the drive had to many bad blocks. I have tried this guide before when something went wrong during an update and the script worked like a charm When I type swapon it tells me /dev/md2 partition 500544 1285 -1ĭo I have a chance to get my Samsung discs to work? What is wrong? I did a factory reset and the entered into putty and executed the commands. It tells me that the drives were in bad condition. ![]() The two 2TB disc are now mounted into the NAS and I can connect to Dashboard. ![]() When the SystemRescueCD is starting there is an error shown at mdadm command. But when I mount the discs into the MyBookLive Duo I can#T go on with the guide. I tested to go on with starting the script and it ran with no problem. What is going wrong here? The two new discs were formatte din fat32. For command mdadm -S /dev/md3 it tells me the same. When I insert command mdadm -S /dev/md2 the terminal tells me that such director doesn’t exist. Following commands work for me with no problem:Īt command mdadm -S /dev/md0 the terminal tells me that the service was stopped. I started the SystemRescueCD and I checked in GPARTED which drive is for the MyBook. I want to add to my MyBookLive Duo two new 2TB discs and I downloaded the script and the image for the MyBook as mentioned above.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |